DKU 5 SERIAL CABLE DRIVER DOWNLOAD

I had a 6 conductor wire cat5 8 conductor would have worked too that I used. After a Google search about “Nokia driver update”, I ended up onto a site offering a download of an updated version of Nokia PC Suite 5. April 27, , 7: After you connect the cable to the Arduino you no longer need to use Hyperterminal. Is there any way I can force the installation software to identify my dku-5 cable as a usb peripheral?

Uploader: Yohn
Date Added: 20 January 2006
File Size: 10.86 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 14714
Price: Free* [*Free Regsitration Required]

Compliments from me aswell on a very good article.

DD-WRT Forum :: View topic – Problem with DKU-5 USB/Serial Console Cable on Linux

There are slightly cheaper alternatives, but a real scrooge googles on. The link from the above post for the drivers is here: Any help will be highly appreciated.

However, experience have shown that some of these cheaper cables can be unreliable and more difficult to be made to work because of lacking documentation, drivers and source code. This connectivity cable lets you charge your phone cablee transferring data to or from your PC.

Ex-Link Cable for C/D/E Series and BD players

Any chance you could send the driver to me or post it somewhere? If you try to exceed mA, bad things can happen. I did a quick probe to confirms this, then attempted to solder the green wire to the via. If you hold the button too long Arduino will eventually give up and report that the programmer is unavailable. Make sure the cable is unplugged!

Programming your Arduino with a DKU-5 cable –

Thanks for eerial great guide. Is there any way I can force the installation software to identify my dku-5 cable as a usb peripheral?

So I guess the numberings is all the same. D, and it can only be programmed once. The next section explains how to make it a cwble nicer.

Hi Thomson, Thanks for fable reply. I can easily find out which of the 3 wires went to where, but how should I find the pinouts of the other pins? It will look like this once done: On the toolbar click the up arrow Opengo to Digital, and choose Blink. If you get it to work, write back and acble us know! Considering the price of a DKU-2 usb cable under 3.

Nokia pop-port LIKE-DKU-5 or CA-42 cable schematic pinout

I said the phone connector not the USB connector. Bluetooth HC07 module with Backplane 4 Srial. In reply to manta’s post on March 25, We need to identify which pin is RX, TX, 3. It was a bit of a headache. Thanks for sharing how to do it. Cabpe page explains how to access the serial on these devices. Hi ramelvert You need to find a version of PC Suite earlier than v6. Sounds like a fun soldering challenge as well: RS uses a negative voltage for a logical 1 and a positive voltage for a logical 0.

Please read the entire article before you begin to modify the cable. One is for audio and the other is for “service”.

If not you should recheck your setup.